I’ve been sampling some CVM fiber (from Heelside Farms) for my next Shave ‘Em to Save ‘Em project. I’ve been thinking I might want to knit a cabled sweater with this fiber, and I was wondering if my drafting method would make a difference in the cable definition. I would expect that, since worsted-spun yarns are often touted for their cable definition, getting closer to that with a semi-woolen yarn would give me cables that ‘pop’ more while retaining the softer, rustic look of a woolen-spun yarn. But a woolen spun yarn would likely be faster to spin, so I wanted to make sure the extra time for a worsted draft was really worth it. So I did a little experiment.
I’m starting from roving, so my options are to create a semi-woolen yarn using a short forward draft, or go for a fully woolen-spun yarn using longdraw. I pulled off a small amount to sample each way, and attempted to spin yarns with approximately the same diameter and ply twist. Both yarns came out to around a DK weight, and with similar ply twist. The woolen-spun sample came out a bit more uneven, and has a bit of a thick and think quality to it. I also had some areas that were underspun in the singles, so breakage was a problem. I would want to spin a more careful sample before I decided to use this for a sweater, but for my comparison purposes I assumed it would suffice. Unsurprisingly the woolen-spun sample had slightly less twist overall in the singles.
I cast on and knit two swatches on US #7 (4.5mm) needles, using a simple 3×3 cable as a test. The woolen-spun swatch came out slightly bigger for the same number of stitches as I would expect – it measured about 3 3/4″ over 20 stitches vs about 3 1/2″ for the semi-woolen swatch. And the cable does appear a bit flatter and less three-dimensional, which I suspected might happen. The semi-woolen swatch also has better stitch definition overall. What surprised me a bit, though, was in that the swatch spun with a short forward draft the stitches appear a bit puffier and seem to fill in the space better. That could be because of my inconsistency in spinning the woolen swatch, though. The other thing that surprised me was the difference in weight of the swatches. I know woolen-spun yarns tend to be lighter, but I was surprised that the two swatches spun from roving were so different. The semi-woolen swatch weighed 4.5 g versus 4.3 g for the woolen-spun – not a huge difference in a swatch of this size. But it made a noticeable difference to the feel of the swatch in my hand. It might be worth sacrificing a bit of cable definition to get a lighter, cozier feeling sweater. I like the look of both cables, and even though the draft did make a difference I’m not sure it was enough to prefer one draft over the other on that basis.
I haven’t decided yet if I will knit a sweater with this fiber – I would need to purchase more of it – or, if I do, which draft I will use. I also want to test how these swatches will stand up to wear – maybe a topic for another post. But I do have an idea of how my choices will affect the final yarn and what I might use it for.